Several homeowners choose to install wood siding on their own. That’s because it gives a sense of freedom and control over the project and one can also save some money! Currently, the fear of infection has also pushed a lot of homeowners to handle such projects on their own.
We understand your concerns and fears. Our team of experts has curated a simple and effective guide about how to install the wood siding Through Houston Siding Company TX. Whether you have done it previously or not, follow these steps and you will be happy with the results.
Step 1: Gather Supplies
Choose a day with good sunlight for wood siding installation. Measure the square footage of the entire walls, subtract the area taken by doors and windows to purchase the wooden planks. Gather the following supplies for the project.
- Tongue and Groove Exterior Wood Plank
- Roll of Moisture Barrier
- Table Saw
- Steel Exterior Finish and roofing nails
- Exterior stain
- Staining Pads
- Hammer
- Crow Bar
- Measuring Tape
- 4’x8’ Sheets of Pressure-Treated Plywood
- Utility Knife
- 1″x2″ Wood Trim
- Exterior Caulk
Step 2: Remove Existing Wall Cladding
Use a hammer and crowbar to remove the existing wall cladding from the house exterior. Remove the old moisture barrier installed between the plywood and cladding.
Step 3: Check For Any Damages
Once the walls are stripped naked, assess them for mold and pest damages. If you see any signs of such damages, it’s best to consult a professional to get rid of it. If the plywood planks are too damaged to fix on your own, give us a call for professional Wood Siding Repair in Houston TX.
Step 4: Install A New Moisture Barrier
Roll out the tar paper or moisture paper on the ground to cut down pieces of it according to the measurements you previously took. A utility knife can be used for cutting it. Now secure the barrier on the wall using galvanized roofing nails. Start from the bottom and make sure each piece is overlapping the previous one a couple of inches to keep the moisture out.
Step 5: Cut The Starter Plank And Prime It
Cut the groove of the starter plank to create a smooth clean edge using the table saw. Prime the back of the plank to create a more effective moisture barrier.
Step 6: Install The First Plank
Draw a straight vertical line on the wall where you plan to install the first plank. Hold the plank up to the level line and secure it onto the plywood backing using stainless steel nails and a nail gun.
Step 7: Cut And Install Vertical Planks
Measure and cut each plank according to the size of the wall. Fit groove edges of the second plank into the tongued edges of the previous plank. Secure it with nails. Once you install the next board, you will not be able to see the nails and this is how you obtain a cleaner, seamless finish.
Step 8: Install Around Doors And Windows
As you reach windows and doors, cut, mark, and measure the wooden planks accordingly.
Step 9: Wrap Edges And Trim
Milter the edges of the boards at the corners of the house to get a clean and finished look. Cut 1″x2″ wood trim to size and secure it with nails.
Step 10: Caulk And Seal
Clean the surface of wood, caulk it at the joints and allow it to dry. Now apply stain and sealant.
For those who are too occupied to handle a DIY project, contact us for Siding Installation in Houston TX. Our team of professionals will get to you with adequate safety measures.
Leave a Reply
Want to join the discussion?Feel free to contribute!